Last month, I spent a lot of time making tiles from wine bottles. However, while the tiles were being fired, I had the time to make a couple of new molds. I made a few different curves, for small self standing clocks, like the curved pot melt clock
seen here.
I also made some different candle holder molds. This one, hold three tea light candles:
I also wanted to make a candle bridge that was a bit smaller than the typical candle bridge using a production mold.
This is just about the same height as the standard candle bridge, but the opening is just big enough for a tea light candle.
And you can see, it's quite a bit shorter in length.
.jpg)
